Goulds 6M051 6" Submersible Well Motor – 5 HP, 230V, Single-Phase, 3492 RPM, NEMA 3R Control Box Required

The Goulds 6M051 is a 5 HP, 3.7 kW, 230-volt, single-phase 6" submersible well pump motor (3492 RPM, 2-pole), sold as a motor only for pairing with a compatible 6" submersible pump end. It features a stainless steel canned design built for long service life in abrasive, sandy well conditions.

• Horsepower: 5 HP (3.7 kW)
• Voltage: 230V, Single-Phase
• Speed: 3492 RPM, 2-Pole
• Service Factor: 1.15
• Rated Input: 24.0 Amps / 4987 Watts
• Service Factor Amps / Watts: 27.5 Amps / 5735 Watts
• Locked Rotor Amps: 124
• Full-Load Efficiency: 74.8%
• Motor Diameter: 5.5"
• Length: 22.95"
• Weight: 95 lbs
• Maximum Water Temperature: 95°F (35°C)
• Minimum Flow Past Motor: 0.5 ft/sec
• Thrust Bearing: Kingsbury-design Type A, 3 shoes -- 3,500 lbs down thrust, 300 lbs up thrust (continuous)
• Required Control Box: CB05MC3R (single-phase motors require a matching Goulds control box, sold separately)
• Certification: NSF/ANSI Standard 61 listed

Construction & Features:

• Frame: Stator coil mounted in a stainless steel frame, completely sealed in a stainless steel cylinder; the space between the stator's can and frame is filled with a specially formulated, heat-resistant patented resin
• Lead Wire: Replaceable plug-in motor lead, 150in (150") long and field replaceable; Ethylene-Propylene rubber insulated chloroprene cabtyre cable, color coded
• Sand Protection: Double-row, grease-packed, lip seals with a carbon steel slinger (baked epoxy coated) to keep sand out of the lip seal area, plus a close-tolerance (.02in) slinger guide fit for additional sand-intrusion protection
• Stator Laminations: High quality electrical-grade silicon steel for high torque, even under nominal voltage variation
• Rotor Balance: Balance rings on each end of the rotor for excellent dynamic balance
• Bearings: Two carbon, water-lubricated sleeve guide bearings to align the shaft and reduce whipping
• Cooling: Water-filled design -- internal cooling water is mixed with antifreeze/antirust liquid, allowing storage down to -22°F (-30°C); two water plugs are provided for filling, draining, and checking the water level
• Corrosion Protection: Stainless steel can housing, shaft and bolts; all other metal parts finished with a baked epoxy coating
• Certification: NSF/ANSI Standard 61 listed (Drinking Water System Components)

Applications: Commercial, irrigation, and agricultural water wells; motor only -- pair with a compatible 6" submersible pump end for a complete installation.

Installation note: this motor must remain fully submerged in water for proper cooling and lubrication, with adequate flow past the motor per the minimum flow rate above. Single-phase motors require the matching control box listed above; wiring must be performed by a qualified electrician in accordance with local codes and the National Electrical Code.