Goulds 8M1504 6" Submersible Well Motor – 150 HP, 460V, Three-Phase, 3500 RPM, 7.52" Diameter

The Goulds 8M1504 is a 150 HP, 110 kW, 460-volt, three-phase 6" submersible well pump motor (3500 RPM, 2-pole), sold as a motor only for pairing with a compatible 6" submersible pump end. It features a baked-epoxy-coated, rewindable water-tight design built for long service life in abrasive, sandy well conditions.

• Horsepower: 150 HP (110 kW)
• Voltage: 460V, Three-Phase
• Speed: 3500 RPM, 2-Pole
• Service Factor: 1.15
• Rated Input: 195.0 Amps / 130700 Watts
• Service Factor Amps / Watts: 220.0 Amps / 152000 Watts
• Locked Rotor Amps: 1060
• Full-Load Efficiency: 85.6%
• Motor Diameter: 7.52"
• Length: 70.08"
• Weight: 661 lbs
• Maximum Water Temperature: 77°F (25°C)
• Minimum Flow Past Motor: 0.5 ft/sec
• Thrust Bearing: Kingsbury-design Type C, 6 shoes -- 10,000 lbs down thrust, 1,000 lbs up thrust (momentary rating, 3 min. max; consult factory literature for continuous ratings by mounting hardware)
• Certification: NSF/ANSI Standard 61 listed

Construction & Features:

• Frame: Baked-epoxy-coated carbon steel frame with water-tight insulated wire
• Insulation: Specially developed, denatured polypropylene coil conductor insulation applying three separate barriers against the motor's cooling fluid, for extended service life
• Sand Protection: Double-row, grease-packed, lip seals with a carbon steel slinger (baked epoxy coated) to keep sand out of the lip seal area, plus a close-tolerance (.02in) slinger guide fit for additional sand-intrusion protection
• Stator Laminations: High quality electrical-grade silicon steel for high torque, even under nominal voltage variation
• Rotor Balance: Balance rings on each end of the rotor for excellent dynamic balance
• Bearings: Two carbon, water-lubricated sleeve guide bearings to align the shaft and reduce whipping
• Cooling: Water-filled design -- internal cooling water is mixed with antifreeze/antirust liquid, allowing storage down to -22°F (-30°C); two water plugs are provided for filling, draining, and checking the water level
• Corrosion Protection: All external and internal cast iron parts finished with a baked epoxy resin coating for excellent resistance to water and corrosion
• Certification: NSF/ANSI Standard 61 listed (Drinking Water System Components)

Applications: Commercial, irrigation, and agricultural water wells; motor only -- pair with a compatible 6" submersible pump end for a complete installation.

Installation note: this motor must remain fully submerged in water for proper cooling and lubrication, with adequate flow past the motor per the minimum flow rate above. Single-phase motors require the matching control box listed above; wiring must be performed by a qualified electrician in accordance with local codes and the National Electrical Code.