Goulds 10CS07412C 3/4HP Submersible Water Well Pump 230V

Goulds 10CS07412C 4" Submersible Water Well Pump, Motor and Control Box, 10 Gallons per Minute, 3/4HP, 230V, 10 Stages, 3 Wire FEATURES -Powered for Continuous Operation: All ratings are within the working limits of the motor as recommended by the motor manufacturer. Pump can be operated continuously without damage to the motor. -Sand Handling Design: Our face clearance, floating impeller stack has proven itself for over 50 years as a superior sand handling, durable pump design. -FDA Compliant Non-Metallic Parts: Impellers, diffusers and bearing spiders are constructed of glass filled engineered composites. They are corrosion resistant and non-toxic. -Discharge Head: Cast 303 stainless steel for strength and durability. Two cast-in safety line loops for installer convenience. -Motor Adapter: Cast 303 stainless steel for rigid, accurate alignment of pump and motor. Easy access to motor mounting nuts using standard open end wrench. -Stainless Steel Casing: Polished stainless steel is strong and corrosion resistant. -Hex Shaft Design: Six sided shafts for positive impeller drive. -Engineered Polymer Bearings: The proprietary, engineered polymer bearing material is strong and resistant to abrasion and wear. The enclosed upper bearing is mounted in a durable Noryl® bearing spider for excellent abrasion resistance. -Check Valve: Screws into discharge head from the top, easily removed for drain-back systems or replacement without disassembling the pump. Spring loaded, o-ring poppet design for positive seal in all conditions. -Crimped Design: For strength, will not separate in the harshest conditions. -Quad-Lock technology: 4 Permanently roll-formed grooves provides the durability and sealing needed in the toughest conditions. NEMA MOTOR - Corrosion resistant stainless steel construction. - Built-in surge arrestor is provided on single phase motors through 5 HP. - Stainless steel splined shaft. - Hermetically sealed windings. - Replaceable motor lead assembly. - NEMA mounting dimensions. - Control box is required with 3 wire single phase units. - Three phase units require a magnetic starter with three leg Class 10 overload protection.