Goulds 3AB2LCB1H2D0 Aquavar AB2 Varible Speed 3HP 208/230V

Goulds 3AB2LCB1H2D0 Aquavar Complete System with AquaBoost II, 208/230V, 10.9 Amps, 3HP, SS Pump 1" Disch, 1 1/4" Suct. 3AB2LCB1H2D0 3 HP controller Wall mount kit 208-230 V input LCB stainless steel pump Transducer Pressure gauge and discharge pipe tee Controller is pre-wired. Flows to 50 GPM. FEATURES The AB2 variable speed pump controller and complete booster package kits, provide an economical answer for municipal water district customers with low water pressure. Both domestic and light commercial applications can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and less wear and tear on your pump and motor. Think of it as "Cruise Control" for your pump! The AB2 is available with a range of flow rates to handle homes with up to four baths, irrigation, filtration and fire suppression systems. Light commercial applications up to 100 GPM at 45 PSI boost. The AB2 is available as either a separate controller or as part of a complete pump package with everything you need to plumb it to a domestic water line. INPUT AND OUTPUT POWER (VOLTAGE AND PHASE) All 1AB2 and 2AB2 require single-phase input power, All controllers output three-phase, 230 Volt power All will work on 1 Phase, 208-230V input power All pumps are equipped with three-phase motors 1151AB2's will work on 1 Phase, 115V input power AQUAVAR ABII CONTROLLER FEATURES Input Power - 208-230V +-15%, single phase (controller only) Output Power - Up to 230V three phase (based on input voltage). Motor rated for 208-230V, +-10%. Maximum Output Current - 4.2 amps - 1AB2 (1 HP) - 6.9 amps - 2AB2 (2 HP) Input Controls - Up and down buttons to set pressure. Signal Lights - Power on, pump running, inverter stopped, pump stopped, standby, faults/errors. Electrical Efficiency - Over 95% at full load Protection Against - Short circuit, under voltage, overload, motor temperature, dead heading, run out, suction loss, sensor fault, bound pump, over voltage, static discharge. Note: Suction loss/run out is set for minimum 10 psi at discharge! Ambient Temperature - 34 F to 104 F Maximum Humidity - 95% at 104 F, non-condensing Air Pollution - Avoid mounting in areas with excessive dust, acids, corrosives and salts. Approvals - Controller Enclosure - Outdoor, NEMA 3R, IP 43 (Rain-tight) Mounting - Wall mount with mounting hardware. Cooling - Convection with cast aluminum heat sink. - 3 HP, 5 HP with temperature fan Transducer - 0.5 - 4.5 VDC with 5 VDC power supply, 100 psi range, 10-foot 3-wire shielded cable. Input Wire - 5 feet of 14, 10 or 8 gauge cable. Depending on size, cable is pre-wired to controller and motor conduit box. Output Wire - 10 feet of 14 gauge cable. Cable is prewired to controller and pump motor (when provided).