Goulds 3AB2 Aquavar ABII Varible Speed 3HP 208/230V

3AB2 Aquavar Complete System 10.9 Amps, 3 HP Controller, Panel mount, transducer and transducer cable. *This product is discontinued and has been replaced by the Goulds AVB10030C0X0X0X1* FEATURES The AB2 variable speed pump controller and complete booster package kits, provide an economical answer for municipal water district customers with low water pressure. Both domestic and light commercial applications can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and less wear and tear on your pump and motor. Think of it as "Cruise Control" for your pump! The AB2 is available with a range of flow rates to handle homes with up to four baths, irrigation, filtration and fire suppression systems. Light commercial applications up to 100 GPM at 45 PSI boost. The AB2 is available as either a separate controller or as part of a complete pump package with everything you need to plumb it to a domestic water line. Input Power: 196-264 Volts, single phase 2-wire, grounded Output Power: Up to 230V three phase (based on input voltage). Motor rated for 208-230 V. Input Controls: Press and hold pressure increase/decrease buttons. Minimum speed and motor overload switch. Signal Light: Power on, pump running, pump stopped, faults/errors. Electrical Efficiency: Over 95% Protection Against: Short circuit, over/under voltage, motor overload, dead heading, suction loss, sensor fault, bound pump, over/under temperature. Ambient Temperature: 14 F to 122 F Maximum Humidity: 95% at 122C F, non-condensing Enclosure: NEMA 3R, IP 22 (Rain-tight) Mounting: Mount vertically, screws included Cooling: Convection with heat sink and fan Transducer: 0.5 - 4.5 VDC with 5 VDC power supply, 80" 3-wire cable. SPECIFICATIONS Controller Temperature Range: Minimum Ambient Temperature: 14 F (-10 C) Maximum Ambient Temperature: 122 F (50 C) Input Voltage: 196 - 264 Volts, 1PH, 2-Wire Grounded Output Voltage: Up to 230V, 3PH based on input voltage Enclosure Dimensions: Height: 18.6" Width: 9.9" Depth: 5.3" Packaged Dimensions: Height: 21" Width: 13" Depth: 8" 3AB2 Specifications: Amperage / HP Range: 10.0 / 3 HP maximum Unit Weight: 20 lbs. Packaged Weight: 23 lbs. Pressure Set Point: adjustable from 20 - 85 PSI with 100 PSI transducer Includes: 100 PSI Transducer, 80" Transducer Cable, Mounting Screws and Ground Clamp Maximum system pressure for 3AB2 with 100 PSI Transducer is 85 PSI