Berkeley 10LT2 Horizontal Deep Water Well Jet Pump, 1 HP

Berkeley 10LT2 Horizontal Multi-Stage Convertible Deep Water Well Jet/ Centrifugal Pump, 1 HP, 1 1/4" Suction, 1" Drive, 1" Discharge, 2 Stages, 115/230 V.

LT2 Series Multi-Stage Jet Pumps are the highest performing pumps available in its category. The LT2 Series Convertible Jets utilize the Berkeley built-in regulator, offering easier priming and better range of performance from a complete line of Shallow Well, 4" Double Pipe, 2" and 3" Single Pipe Jet Packages. Pump may also be operated as a self-priming centrifugal (to 25 ft.) to provide a wide range of high pressure applications.

Applications: Water systems and sprinkling... for homes, farms and cottages.

Specifications: Body - One-piece rugged cast iron
Pump and Motor Shaft - 416 stainless steel
Impeller - Polycarbonate
Diffuser - Corrosion-resistant cast iron
Pressure Switch Pre-Set - 30-50 PSI
Suction Ports - Drive-over-Suction

Features: Automatic Pressure Regulator - Faster-acting and quieter, design eliminates “hunting” for correct drive pressure. New improved stem and guide are precisely molded to assure efficient, trouble-free performance on all deep wells. See ordering information (Deep well only).
Quality Construction - Close grained cast iron pump body is rugged, one-piece unit, specially treated to resist corrosion. Drain port provided for easy winterizing.
Precision-machined Diffusers - Assure faster priming.
Mechanical Shaft Seal - Precision lapped and highly polished carbon-ceramic, stainless steel construction. Internal design guarantees continuous water lubrication for maximum protection.
Polycarbonate Impellers - Precision molded for perfect balance, and ultra-smooth for highest performance and efficiency.
Motor Windings - Superior insulation materials protect against excessive moisture and contaminants to ensure prolonged motor life.
Dustproof Cover - All electrical components are protected from dirt, dust and insects by a dustproof canopy. Ventilating air cannot contaminate vital switching components. This eliminates the most common cause of motor failure.
Balanced Rotor - Rotor is die cast under high pressures for uniform performance and greater efficiency; dynamically balanced.
Heavy-duty Ball Bearings - Shielded, permanently lubricated bearings are extensively tested to ensure extended life and smooth, quiet operation.
Pump and Motor Shaft - One piece threaded shaft for positive impeller drive and alignment. Shaft is stainless steel for maximum corrosion resistance.